Clips & Pins
Do you need a panel or bracket that can be removed in seconds without tools? In this category we collect clips and locking pins for your car, such as quick release pins from Moroso. These parts are for you if you are working on a project where parts must stay secure while driving but be quick to remove at the track or in the garage.
What does a quick release pin do?
A quick release pin is a locking pin that is typically held in place by a spring-loaded ball in the tip until you pull it out. It is used where a part must stay securely in place but be removable without tools, such as a panel or a bracket that is regularly taken off during a project. Under quick release pins you will find, for example, pins from Moroso in several diameters and lengths.
How to choose the right pin
Dimensions are listed in inches on each product, and both diameter and length must suit your installation:
- Diameter: e.g. 1/4, 3/8 or 1/2 inch. The pin should fit the hole without much play, as play can cause wear and rattling. How much load the pin can handle depends on diameter, material and how it is loaded.
- Length: from 1 to 3 inches. Measure the total thickness of the parts the pin must pass through, so the locking mechanism comes fully clear on the other side.
- Quantity: single or in a 2-pack, depending on how many mounting points you have and whether you want a spare on hand.
Installation and maintenance
The holes must line up so the pin can be pushed through without being forced, otherwise the locking mechanism can be damaged. After installation, check that the pin cannot be pulled out without being released. Dirt and road salt can make the mechanism stiff, so clean the pin and keep it lightly lubricated. If a part needs to be closed tool-free in another way, quarter-turn fasteners can be an alternative, and under fasteners and hardware you will find the other parts for the assembly.
Frequently asked questions
How do I find the right length for a quick release pin?
Measure the total thickness of the parts the pin must hold together, and choose a length that leaves room for the locking mechanism to pass fully through. If the pin is too short, it will not lock. If it is very long, it can stick out and get caught.
Can a quick release pin replace a bolt?
It depends on how the part is loaded. A pin is designed for quick removal, whereas a bolt with a nut is tightened down. For parts under heavy load or strong vibration, you should consider whether a bolt is the safest choice.
Why is the pin stiff to pull out?
This is often caused by dirt, rust or road salt in the locking mechanism, or by holes that do not line up. Clean the pin, lubricate it lightly, and check that the parts are seated correctly before pushing the pin through.