0

External Wastegates

Is your boost pressure fluctuating, or can the internal wastegate no longer keep up with your turbo project? An external wastegate routes excess exhaust gas around the turbine and can give you more precise boost control on engines with higher power targets.

How an external wastegate works

An external wastegate is typically mounted on the exhaust manifold before the turbine and opens when boost pressure reaches the spring setting. The spring pressure is often stated in the product name, e.g. 7 or 14 psi on the Turbosmart CompGate40 and PowerGate60, and typically determines the lowest boost pressure you can run.

How to choose the right wastegate

Size alone does not determine which of our wastegates suits your project. Consider several factors:

  • Valve size – in the names e.g. 40, 45, 50 or 60 – relative to power target and the turbine's gas flow.
  • Spring pressure relative to the desired base boost pressure.
  • Pneumatic or electronic control: the Turbosmart Electronic StraightGate ESG40 and ESG50 are electrically controlled and typically require a compatible engine management system.
  • Space at the exhaust manifold and for the dump pipe.

Installation and maintenance

Whether the dump pipe is routed back into the exhaust or out separately affects both sound and vehicle inspection. Approval depends on the product and the car and must be checked for the specific part number. Regularly check gaskets for exhaust leaks, and keep an eye on whether the valve seals tightly – a leaking valve can result in lower boost pressure than expected.

Frequently asked questions

What is the difference between an electronic and a pneumatic wastegate?

A pneumatic wastegate opens via a spring and pressure from the intake, while an electronic one, e.g. the Turbosmart ESG40, is actuated electrically and controlled by the engine management. This can allow more flexible regulation but typically requires compatible engine management.

Which spring pressure should I choose?

Typically choose a spring at or slightly below the lowest boost pressure you want to run. Higher boost pressure is then achieved with a boost controller, while a spring that is too stiff can make low boost pressure impossible.

Can an external wastegate be approved for road use?

It depends on the product, the car and especially on how the dump pipe is routed. A separate pipe without silencing can cause problems with noise and inspection, so check approval for the specific part number before installation.

View as Grid List
Sort by
Display per page