0

Gasket Material

Is there no ready-made gasket for the cover, or does the original one no longer fit? With gasket material in sheets, you cut the gasket yourself to match the flange. This category is for you if you restore, modify or make custom parts and need a seal in exactly the shape and thickness your project requires.

What is gasket material used for?

The sheets are used when a gasket has to be made from scratch, e.g. for a cover, a thermostat housing or a flange where no ready-made gasket exists. If you need a pre-cut gasket for a specific spot on the engine, you will find it under engine gaskets. The full range is under gaskets and seals.

How to choose material and thickness

The choice depends on the fluid, the temperature, the condition of the flange and how much the gasket may be compressed. The sheets in this category are from Fel-Pro, e.g.:

  • Cork-rubber from 1/16" to 1/8", typically used where a soft gasket needs to fill small irregularities.
  • Rubber-cellulose and rubber-fiber in 1/32" and 3/64", typically used between flat surfaces.
  • Karropak and Pro-RAMic 301 in wider sheets, where you should check the product specifications for temperature and fluids.

A thicker gasket is not automatically better. It can change the distance between the parts and settle more when the bolts are tightened. Also check that the sheet is large enough for the whole part.

Cutting and installation

Clean the flanges completely of old gasket and oil, and trace the outline of the part directly onto the sheet. Bolt holes can be made with a hole punch set. Tighten the bolts evenly in a criss-cross pattern according to the car's specifications, as a gasket that is overtightened can be squeezed out. For shafts and passages, a flat gasket is rarely the solution. Here you should instead look at oil seals or O-rings.

Frequently asked questions

Can gasket material be used at the exhaust manifold?

It depends on the material and the temperature at the specific location. Check the temperature limit in the product specifications. At the exhaust manifold, ready-made gaskets designed for high heat are typically used.

Should I use gasket sealant with the sheet material?

It depends on the material, the surface and the car's specifications. Too much gasket sealant can cause the gasket to slip or get into passages. Follow the instructions for the specific part number.

How do I find the right thickness?

Measure the old gasket with a caliper and choose a thickness close to it. Only deviate if the distance between the parts does not matter, which means not on parts with bearings, gears or fixed clearances.

Why is my homemade gasket leaking?

Typical causes are residue from the old gasket, a bent flange, uneven tightening or a material that cannot withstand the fluid or temperature. Check the flange with a straightedge before you cut a new gasket.

View as Grid List
Sort by
Display per page

Gasket Materials

fel3023
Fel-Pro 3023 Karropak 1/32in (18in x 36in) Sheet Gasket Making Material
17,96 € excl. VAT

Gasket Materials

fel3005
Fel-Pro 3005 Cork-Rubber 1/16in (18in x 36in) Sheet Gasket Making Material
25,37 € excl. VAT

Gasket Materials

fel3047
Fel-Pro Karropak 1/16in (12in x 36in) Sheet Gasket Making Material
23,82 € excl. VAT

Gasket Materials

fel3099
Fel-Pro 3099 Karropak 1/16in (18in x 5 Yds.) Roll Gasket Making Material
121,39 € excl. VAT

Gasket Materials

fel3098
Fel-Pro 3098 Karropak 1/32in (18in x 10 Yds.) Roll Gasket Making Material
121,82 € excl. VAT