Valve Cover Grommets
Is oil seeping out around the bolts on your valve cover? It can be caused by the small grommets under the bolts if they have become hard or cracked. In this category you will find grommet and insulator sets for valve covers, for when you are replacing the gasket, maintaining the engine or building a project.
What grommets and insulators do
The valve cover is typically secured with bolts that pass through the cover itself. The grommets sit around the bolts and seal so that oil does not seep out through the bolt holes. The insulators can also dampen vibrations and keep the cover free of direct metal-to-metal contact at the bolts. Over time, heat and oil can make the rubber hard so it loses its sealing ability. That is why the grommets naturally belong with a valve cover gasket replacement – see also engine gaskets and seals.
How to choose the right set
The sets are made for specific engines, so fitment depends on car, model year and engine. In particular, check:
- Part number: Compare e.g. ES 72180 or ES 71189 with the parts information for your engine.
- Model and year: Fel-Pro offers sets for e.g. Honda Civic, Ford Ranger, Toyota Tacoma and Jeep Compass, but the same model can have several engine variants.
- Set contents: Check whether you get grommets for all bolts and whether the valve cover gasket must be bought separately.
Installation and maintenance
Clean the mating surfaces and bolt holes before fitting the new grommets. Tighten the bolts to the manufacturer's torque specification – too tight can crush the rubber so it seals poorly, and too loose can cause leaks. If you see oil elsewhere on the engine, the cause may lie in e.g. oil seals or O-rings. You will find all types of seals together under gaskets and seals.
Frequently asked questions
Should the grommets be replaced together with the valve cover gasket?
It is typically recommended, because the grommets are exposed to the same heat and oil as the gasket. If they are hard or cracked, oil can still seep out at the bolts even though the gasket is new.
How can I tell if the grommets are worn?
Signs can be oil around the bolt heads on the valve cover, or rubber that is hard, flattened or cracked. Also check that the oil is not coming from another seal further down the engine.
Can I reuse the old grommets?
This is not recommended if they are hard, deformed or have settled. Rubber that has been compressed for a long time can lose its elasticity and therefore seals poorly when the cover is refitted.
How do I find the right set for my engine?
Go by the part number, e.g. ES 72840, and compare it with your car's parts data for model, year and engine. The same model can have several engine variants with different valve covers and bolts.