Hose Ends
Is fuel seeping at the joint, or do you need to connect a new hose to a pump or filter? The hose ends here connect PTFE and braided hoses to the rest of the system and are for you if you are building a fuel, oil or cooling circuit in your project.
What does a hose end do?
The hose end is clamped onto the hose and provides a threaded connection, typically in AN size, that can be screwed onto fittings at the pump, filter, cooler or fuel rail. The swivel nut lets you turn the hose into position without twisting it. For permanent fitting with a crimping tool, you will find crimp hose ends in the subcategory.
How to choose a hose end
- Hose type: A hose end for PTFE hoses typically has an olive insert that clamps around the inner liner and normally does not fit rubber-based braided hoses. DeatschWerks, for example, offers both PTFE and CPE versions.
- Size: The AN size, e.g. 6AN or 8AN, must match both the hose and the connection. Which size you need depends on flow, fluid and power target.
- Angle: Straight, 45 or 90 degrees. Choose based on space and hose routing so the hose does not kink or rest against hot parts.
- Application: Some hose ends are designed for a specific system, e.g. Russell EFI hose ends.
Installation and maintenance
Cut the hose straight and clean, and follow the manufacturer's instructions – PTFE hose ends typically require a new olive if the joint is taken apart. Tighten to the recommended torque, and pressure-test the system before starting the engine. Inspect the joints regularly for moisture and loose nuts, especially near the exhaust manifold and turbo. Other brands in the category include Fragola, Vibrant and GReddy.
Frequently asked questions
Can I use the same hose end for PTFE hose and braided rubber hose?
Typically not. PTFE hose ends seal with an olive against the hard inner liner, while hose ends for rubber-based hoses grip the hose differently. Always check that the hose end is designed for your specific hose type.
Can a PTFE hose end be reused?
The body and nut can often be reused, but the olive insert deforms during installation and should typically be replaced when the joint is taken apart. Follow the manufacturer's instructions for the specific product.
What is the difference between a crimp hose end and a reusable screw-on hose end?
A crimp hose end is pressed on with a special tool and cannot be taken apart again. A screw-on hose end can be fitted with ordinary tools and can often be disassembled. The choice depends on your tools and whether you want to be able to change the hose routing later.