Carbide Burrs
Which burr shape reaches into a narrow port, and which leaves a smooth surface on a bracket? Carbide burrs fit in a die grinder and remove metal in a controlled way. We stock burrs from COMP Cams for you who machine cylinder heads, manifolds and other parts in your own workshop.
Shapes and cuts
The shape of the burr determines where it can work. Among the burrs from COMP Cams you will find, for example, ball for fillets and round ports, flame and tree for shaping transitions and reaching into tight areas, and cylinder with radius end for flat surfaces with a soft rounding towards the edge. Several variants have an aluminium cut – a coarser cut that typically clogs less in soft metals. For steel and cast iron, a standard cut is normally used.
How to choose a carbide burr
- Material: Choose the cut according to whether you are working aluminium or steel and cast iron.
- Shape: Consider the geometry of the part – ball for hollows, flame and tree for transitions, cylinder for surfaces.
- Length: A long version can reach deeper into, for example, a port, but can vibrate more than a short one.
- Shank: Check the shank diameter for the specific part number against the collet in your die grinder.
Use and maintenance
Keep the burr moving and let the speed do the work rather than pressing hard. Observe the manufacturer's maximum speed, and choose power tools where the speed can be adjusted to the task. Clean stuck metal from the cut, and replace the burr when the cutting edges are dull or damaged. Always wear eye protection.
Frequently asked questions
What is the difference between an aluminium cut and a standard cut?
An aluminium cut typically has fewer and coarser flutes, so chips clear the burr more easily in soft metals. A standard cut is typically better suited to steel and cast iron, where it can give a finer surface finish.
When does a 6-inch burr make sense instead of a 2-inch?
The long version can reach deeper into, for example, the ports of a cylinder head. On the other hand, it can vibrate more, so typically work at lower speeds and with light pressure. For open parts, the short version is often easier to control.
Why does the burr clog, and what do I do about it?
It typically happens when soft metal such as aluminium sticks in the cut, for example from too much pressure or the wrong cut. Choose an aluminium cut for soft metals, keep the burr moving, and clean the cutting edges before you continue.