Relays
Does the switch get hot when you turn on the auxiliary lights or the electric fan? A relay lets a small control current switch a heavy load, protecting the switch and wiring. This category includes 12V and 24V relays, relay sockets and starter relays for e.g. ATVs and snowmobiles.
How to choose the right relay
The coil voltage must match the electrical system: a 12V relay for a 12V system and a 24V relay for vehicles with a 24V system. After that, load and function determine the choice:
- Current rating: The relay's amp rating must be higher than what the load draws – including at start-up, when e.g. motors and bulbs can draw more. From Hella you'll find e.g. 20/40A, 40A and 60A.
- Contact type: SPST switches one circuit on and off, while SPDT switches between two outputs. A 20/40A rating typically means the two contacts can handle different loads.
- Features: Some relays have a built-in resistor that can suppress voltage spikes when the coil switches off, and a bracket so the relay can be bolted in place.
Starter relays for ATV, UTV and snowmobile
Arrowhead offers starter relays for e.g. Honda, Suzuki and Yamaha as well as Can-Am ATVs and UTVs and Lynx snowmobiles. The starter relay carries the high current from the battery to the starter motor. If it clicks without the engine turning over, the contacts may be worn, but a weak battery or poor connections can cause the same symptom. Compare terminals and part number with the original relay, as fitment depends on model and year.
Installation and wiring
A relay socket, e.g. Hella's mini socket with five terminals, provides secure connections and makes the relay easy to replace. Choose wire gauge according to current and length from our wires and cables, connect with suitable connectors and terminals, and protect the routing with wire loom. Fit a fuse close to the battery on the heavy supply line.
Frequently asked questions
What is the difference between an SPST and an SPDT relay?
An SPST relay has one normally open contact that switches a circuit on and off. An SPDT relay has a changeover contact, so the current is routed to one of two outputs – e.g. when two functions must never be on at the same time.
Why does the starter relay click without the engine starting?
The click shows that the coil is getting power, but the contacts may be burnt. However, low battery voltage, corroded cable lugs or a faulty starter motor can cause the same symptom, so measure the voltage at the relay before you replace it.
Can I use a 12V relay in a 24V system?
No, the coil is designed for a specific voltage. A 12V relay on 24V can overheat and fail, while a 24V relay on 12V typically won't pull in reliably. Always choose the relay according to the vehicle's system voltage.