0

Misalignment Spacers

Does your rod end hit its angle limit before the suspension has reached full travel? Misalignment spacers sit on each side of the ball in a spherical joint and can give the joint more angular freedom. They are for you if you are building or adjusting a suspension with rod ends.

What does a misalignment spacer do?

A misalignment spacer has a stepped section that goes into the ball's bore and a wider section that rests against the bracket. It creates distance between the rod end housing and the bracket, so the joint can typically angle further before the housing makes contact. How much extra angle you get depends on the rod end, the bracket and the spacer's dimensions. The spacers from QA1 in this category are made of stainless steel, and you can find more types of spacers under spacers and bisquits.

How to choose the right spacer

  • Outer diameter: the inserted section must fit the bore in the ball.
  • Inner diameter: must fit the bolt you mount it with. Dimensions are given in inches in the product name, e.g. .5in OD x .375in ID.
  • Ball width: choose standard or narrow ball width according to the ball in your rod end.
  • Width: must match the distance between the bracket ears. Check the product description for how the width is specified.

Check the dimensions of both the rod end and the bracket before ordering. After installation, you should cycle the suspension through its full travel to make sure nothing binds, and tighten the bolt according to the manufacturer's instructions. Need other sizes? See more parts from QA1.

Frequently asked questions

What dimensions do I need to know before choosing a spacer?

You need to know the bore in the ball, the bolt diameter, the ball width and the gap in the bracket. The spacer dimensions are given in inches in the product name, so compare them with the rod end data in the same unit.

What is the difference between standard and narrow ball width?

It refers to the width of the ball in the rod end. The spacer must match the ball type you have, otherwise it may not sit correctly. Check the rod end specifications and choose your spacer accordingly.

How do I check the spacers after installation?

Cycle the suspension through its full travel and look for places where the housing or bracket makes contact. Regularly check that the bolt is correctly tightened and that there is no play or wear marks at the spacer.

View as Grid List
Sort by
Display per page

QA1 Misalignment Spacer

qapSG12-108
QA1 Standard Ball Width High Misalignment Spacer - .75in OD x .625in ID x 1.875in Wide - S.S.
20,81 € excl. VAT

QA1 Misalignment Spacer

qapSN20-1211-H
QA1 Narrow Ball Width High Misalignment Spacer - 1.25in OD x .75in ID x 2.625in Wide - S.S.
34,62 € excl. VAT

QA1 Misalignment Spacer

qapSG10-84
QA1 Standard Ball Width High Misalignment Spacer - .5in ID x 1.25in Wide - Stainless Steel
20,80 € excl. VAT