Specialty Hand Tools
If the clutch disc sits off-centre when the gearbox is lifted into place, it can be difficult to get the input shaft to engage. A clutch alignment tool keeps the disc in line with the flywheel while the pressure plate is tightened. It is for you if you change your own clutch in the workshop or garage.
What a clutch alignment tool does
When the clutch is replaced, the disc sits loose between the flywheel and pressure plate until the bolts are tightened. The tool is passed through the disc hub and into the pilot bearing in the crankshaft, so the disc is held centred. If the disc is offset, the gearbox input shaft can be hard to fit, and you risk putting strain on the hub or pilot bearing during installation. From ACT, the tool is available in versions where the product name states the car model, e.g. Honda S2000, Audi TT Quattro, Dodge Neon and BMW 330Ci.
How to choose the right tool
The tool must match both the spline profile of the clutch disc and the internal dimensions of the pilot bearing. The dimensions typically depend on the engine and gearbox and not only on the car model, so check the part number against your car and the clutch you are fitting. If you switch to a clutch with a different disc than the original, you should make sure the tool still fits the hub.
Installation and storage
Tighten the pressure plate bolts gradually and in a crisscross pattern with the tool in place, and only remove it once the plate is tightened to the car manufacturer's specification. The tool should pull out easily; if it is stuck, it may indicate that the disc is offset. For the bolts themselves you will need suitable wrenches and a torque wrench. The alignment tool takes up little space and can be stored with the rest of your hand and specialty tools, so it is ready for the next clutch job.
Frequently asked questions
Can I use the alignment tool on a different car than the one in the name?
Only if the spline profile and pilot bearing dimensions match. The product name states the car model the tool is made for, but the engine and gearbox variant can affect the dimensions, so always check the specific part number.
What happens if the clutch disc is not centred?
The gearbox input shaft can be difficult to insert, and you may end up straining the disc hub or the pilot bearing. In the worst case, the gearbox has to come off again so the disc can be realigned.
Can I centre the clutch disc by eye?
It can be done with experience, but the precision is typically poorer, and a mistake is only discovered when the gearbox goes on. A tool that fits the disc and pilot bearing gives a more consistent result.