0

U-Joints

Does it clunk when you pull away, or does the driveshaft shake at a certain speed? Then a worn U-joint may be the cause. We stock U-joints for driveshafts and axle shafts – e.g. for Jeep models and Dana 44 axles as well as ATVs and UTVs from Polaris, Can-Am, Yamaha and Kawasaki.

What does a U-joint do?

The U-joint connects the driveshaft to the yoke or flange and lets the shaft transmit power even as the angle changes when the suspension works. The joint consists of a cross with four bearing caps with needle bearings. Wear typically shows up as a clunk when switching between throttle and engine braking, vibrations at certain speeds, squeaking or rust-red dust at the bearing caps.

How to choose a U-joint

  • Size: the bearing cap diameter and the measurement across the cross determine the fit – compare with the old joint and the part number.
  • Retention: external or internal snap rings depend on the yoke design.
  • Greasable or sealed: a joint with a grease fitting, e.g. from OMIX for Dana 44, can be refilled with grease, while a sealed joint cannot be serviced.
  • Load: power, shaft angles and driving in mud and water affect which joint suits your project.

Installation and maintenance

The bearing caps are typically pressed out and in with a vise or press tool; hammer blows can damage the needle bearings. At the same time, check the driveshaft yokes for play. For ATVs and UTVs we have U-joints from EPI, and in this category you will also find Moroso, Revolution Gear & Axle and Driveshaft Shop. If the whole shaft needs replacing, see driveshafts or CV axles.

Frequently asked questions

How can I tell that a U-joint is worn?

Typical signs are a clunk when pulling away or lifting off the throttle, vibrations that increase with speed, squeaking from the shaft and rust-red dust at the bearing caps. Rotate the shaft back and forth by hand – noticeable play in the joint indicates wear.

Can I replace the U-joint without replacing the whole driveshaft?

Typically yes, if the shaft and yokes are undamaged. Mark the relative position of the parts before disassembly so the balance is preserved. If the bearing bore in the yoke is worn, or the shaft vibrates after the replacement, it may require balancing or replacement.

How often should a greasable U-joint be greased?

It depends on the vehicle and the use. Driving in water, mud and off-road typically requires more frequent greasing than road driving. Follow the manufacturer's instructions, and pump in grease until fresh grease comes out at all four bearing caps.

View as Grid List
Sort by
Display per page