Valve Covers
Do the rocker arms hit the old cover after a cylinder head swap, or does the engine bay need a cleaner finish? Valve covers seal the top of the cylinder head and protect the valvetrain. We carry covers in aluminium and steel for both stock heads and aftermarket heads.
How to choose a valve cover
The most important thing is that the cover fits your specific cylinder head. A cover for a stock head, e.g. Mopar 426 Hemi, will not necessarily fit an aftermarket head, which is why there are covers designed for specific heads, e.g. Edelbrock with an 18-degree valve angle. Also consider:
- Height: a taller cover of e.g. 3 or 3.5 inches can make room for rocker arms and valve springs that won't fit under the original. At the same time, check the clearance to the intake and other parts around the engine.
- Material: chrome-plated stamped steel, polished aluminium or fabricated aluminium with a billet rail. The choice depends on rigidity, sealing and looks.
- Breathers and baffles: baffles can reduce oil being drawn out through the breather, and some covers have fittings for breathers or oil filling, e.g. with a 12AN connection.
- Quantity: some covers are sold in pairs, others individually.
In this category you will find, for example, covers from Moroso for Ford 302/351W and Chevrolet Small Block, a blue aluminium cover from OMIX and covers from Wehrli.
Installation and sealing
Use a new gasket and tighten the bolts evenly according to the manufacturer's instructions. Overtightened bolts can deform thin steel covers in particular and cause leaks. For a consistent look, you can add a matching oil filler cap.
Frequently asked questions
Why do some valve covers have baffles?
Baffles are plates on the inside that can reduce oil from the rocker arms being flung directly into the breather. This can mean less oil mist in the intake or breather filter, but the effect depends on the engine and the ventilation system.
When should I choose a taller valve cover?
When rocker arms, valve springs or other valvetrain parts won't fit under your current cover. Measure the clearance with the parts you are installing, and check the clearance to the intake and surrounding parts at the same time.
Why is my valve cover seeping oil?
Typically it is caused by an old or incorrect gasket, unevenly tightened bolts or a deformed cover. Excessive crankcase pressure, e.g. due to a clogged breather, can also push oil out at the gasket.